Home | Product Index | Pond Products | Fountains | Articles | Gallery | Garden | Shipping |View Cart

 

Instructions

Installing an Aqua Art Retro Drain -
Using Mid Size Open Air/Submersible Type Pump

See Illustrations and Legend below Instructions:


• Pump should be placed outside of the pond, below surface water level of the pond. This type of pump has little or no suction lift abilities. They are not self priming. A “flooded suction” position is the best environment for their longer life and less work load. Please read these helpful articles selections on our web site: Pump Principles - Pond vs. Pool and Guidelines for Pump & Pipe Useage

• We recommend placing the pump - along with union(s) and leaf trap - in an irrigation valve box. This keeps the pump, unions and leaf trap free of surrounding landscape soil and provides for clean and clear minimum maintenance access to these components which are the heartbeat of your pond system. Time well spent now will save many hours during the long life of the system.

• Place a swing (not spring) check valve between the RetroDrain and the leaf trap as well as an isolation valve, typically a knife valve.

• Use a minimum pipe size of 1 1/2” to plumb both suction and discharge sides of the pump, especially if the pump port size is 1/2”, 3/4”, 1”, 1 1/4” as pump port size does not dictate plumbing pipe size. This is a very important point. Pump Principles - Pond vs. Pool and Guidelines for Pump & Pipe Useage.

• Avoid the use of “ expedient” plumbing “methods” such as hardware store “hose”, the use of hose clamps, brass fittings, vinyl/clear “tubing”. These materials / techniques are bound to cause extra work in the long run. Instead, take the little bit of extra time to work with PVC/ABS pipe and you will be rewarded with a more minimum maintenance installation. We offer a booklet.pdf from IPS weld on glue manufacture on the best procedures for gluing plastic pipe. We highly recommend this brand of glue over all others. Not available at “ home improvement stores” rather from landscape or plumbing supply houses and better pond supply outlets.

Above photo illustration shows a "through the wall" bulkhead plumbing installation

  1. 1 1/2" Swing check valve (clear shown here) to RetroDrain
  2. 90° (1/4 bend) ABS 1 1/2" black fitting
  3. 1 1/2" ABS male adapter
  4. Surface water level of the pond (shown as a red line)
  5. Pond wall or membrane
  6. Top edge of pond
  7. 1 1/2" ABS (or PVC) male adapter
  8. Bulkhead (1 1/2" lock nut)
  9. 1 1/2" knife valve (isolates equipment from pond)
  10. 1 1/2" x 2" slip x slip reducer bushing
  11. 1/2 union with slip socket (comes with leaf trap)
  12. Leaf trap #P3571
  13. 1/2 union with slip socket (comes with leaf trap)
  14. 2" x 1" reducer bushing slip x FPT
  15. 1 1/2" x 1" reducer bushing FPT x slip spigot
  16. 1 1/2" PVC slip x slip union
  17. 90° (1/4 bend) ABS 1 1/2" black fitting
  18. Teton Dynamics XR1200 with 1" male threaded ports on suction and discharge

Above photo illustration shows an "up and over the wall" plumbing installation.
You won't need the "through the wall bulkhead".

Tech Support Line: 707 853 0118. Ask for Bruce



Top of Page